实木门门套安装
Installation of solid wood door pocket
1、门套装配连接处，应严密、平整、无黑缝；固定配件应锁紧；门套对角线应准确，2米以内允许公差≤1毫米，2米以上允许≤1.5毫米；
1. The assembly joint of the door pocket shall be tight, flat and without black seam; the fixed accessories shall be locked; the diagonal line of the door pocket shall be accurate, and the allowable tolerance within 2 meters shall be ≤ 1 mm, and that over 2 meters shall be ≤ 1.5 mm;
2、门套装好后，应三维水平垂直，垂直度允许公差+2毫米，水平平直度公差允许+1毫米；门套与墙体间结合应有固定螺钉（每一米不少于3个）；门套宽度在200毫米以上应加装固定铁片；门套与墙之间缝隙用发泡胶双面密封，发泡胶应涂匀，干后切割平整。
2. After the door pocket is installed, it should be three-dimensional horizontal and vertical, the allowable tolerance of perpendicularity is + 2 mm, and the tolerance of horizontal flatness is + 1 mm; the combination between the door pocket and the wall should have fixing screws (no less than 3 per meter); the door pocket width should be more than 200 mm, and the fixed iron sheet should be installed; the gap between the door pocket and the wall should be sealed with foam rubber on both sides, and the foam adhesive should be evenly coated and cut flat after drying.