| 室内门标准测量方法 |
| 添加时间：2018/1/31 16:19:20 浏览次数： |
| 门洞尺寸的定义： The dimension of the definition: 门洞尺寸是指未安装门的门洞净空尺寸大小，包括门洞宽度、门洞高度、墙壁厚度；单位一般用毫米表示。 Door size refers to the size of the clearance is not installed on the door, including the width and height of the hole, the wall thickness; units generally use millimeter. 门洞尺寸的标准： The size of the standard: 室内门的标准门洞尺寸为：2050mm×860mm×240mm The indoor door standard door size: 2050mm * 860mm * 240mm 门洞尺寸的测量方法 The dimension of the measurement method 说明： Explain： 对于门洞的测量， For the measurement of, 以下的门洞是已经装修好完成的不再进行修改的门洞尺寸。 The following is the doorway has good decoration done not modify its size. 对于还在进行装修过程的门洞建议做成一高2050mm宽860mm的门洞。根据这个尺寸的门洞是生产出来的成品门的展示效果是最佳的。是符合人体工程学和美学的。 For in the renovation process of a high 2050mm wide doorway suggested 860mm door. According to the size of the door is produced by the finished product door display effect is the best. Ergonomic and aesthetic. 1.实际测量门洞的宽度和高度。要对门洞的上、中、下三处进行测量是否一致，如果不一致，以最窄处为准，但误差不得超过2㎜。 1. the actual measurement of the width and height. To it, the three measure is consistent, if not consistent with the narrowest point, but the error is not more than 2 mm. 2对于误差超过20mm的要对墙洞进行修正，修正可以用水泥砂浆或石灰进行修正。 2 for the error of more than 20mm, the wall hole should be amended, and the amendment can be modified with cement mortar or lime. 3.门洞墙体的厚度测量也要量上、中、下三处，看墙体的厚度是否一样，同时也要看左右墙体和门洞顶上墙体的厚度是否一样，不一样的取它们最大值，但误差不得超过5㎜。 The wall thickness measurement of 3. also to the amount of three, see the thickness of the wall is the same, but also to look around the wall and door wall thickness is the same, not the same as taking their maximum value, but the error is not more than 5 mm. 4.如果墙体厚度的误差超过5㎜，就需要进行修正。 4. if the error of wall thickness more than 5 mm, it needs to be corrected. 5.如果墙壁为丁字墙，就需要用细木工板做宽度为50-60mm的假墙壁安放门套线。厚度同墙壁的墙体厚度一样。 5. if the walls for t-wall, you need to use Blockboard width 50-60mm fake walls placed door line. The thickness is the same as the thickness of the wall. 6.门洞墙体的厚度最低不少于80㎜。低与80mm尺寸的门框的强度不是很大，对门的支撑力度不够。如果小于80mm需要将墙体的厚度加厚到80mm以上。 The 6. wall thickness of not less than the minimum 80 mm. The strength of the door frames of low and 80mm sizes is not large, and the support of the door is not enough. If less than 80mm, the thickness of the wall should be thickened to more than 80mm. 7.门洞上面有突出来的横梁时，上面门套线无法安装。也需要用细木工板做50-60mm高的假墙壁，其长度于门洞宽度一样，深度和门洞厚度一致。 The 7. openings above the beam protruding, cannot be installed above the door line. Also need to use blockboard 50-60mm high false walls, its length to width and depth and the thickness of the same. 的高度来定。 The altitude is fixed. 8.门洞有台阶的。有台阶一面的脸套线要加上台阶高度，具体尺寸根据台阶 的高度来定。 The 8. step. With the steps, one side of the face line, plus the height of the step, the specific size according to the height of the steps. 9.卫生间和厨房门洞墙体的厚度特别要注意的是墙体上贴墙砖的厚度。一般单面贴砖加厚25㎜，两面贴砖加厚50㎜，具体情况由设计师与客户及装修公司三方面签字确认。最终的尺寸要包括墙砖的厚度。最好在墙砖贴好后测量。 9. kitchen and bathroom wall thickness especially tile wall thickness. Single side tiling thickening of 25 mm, 50 mm thick tiles on both sides, the specific circumstances of the designers and customers and three signed decoration company. The final size shall include the thickness of the wall tiles. It is best to measure after wall tiles are attached. 10.测量时注意门的开启方向，开启方向定义为：从门的正面看，把手在左为左开，把手在右为右开。（一般室内门不要求开向） 10. when measuring, pay attention to the opening direction of the door. The opening direction is defined as: from the front of the door, the left hand is left, and the right hand is opened on the right. (general indoor doors are not required to open.) 11.垭口、窗套测量基本上同门洞测量一样，只是尺寸按实际测量结果记录，不用扣除。 11. pass, basically the same set of measurement window hole measurement, but the size according to the actual measurement result recording, without deduction. 垭口：指不装门或不用其他东西屏蔽的墙体开口，比如客厅和阳台、卧室和阳台之间的开口 Pass: refers to the not gate or other things without shielding wall openings, such as between the living room and balcony, bedroom and balcony opening 窗套：指窗框和门框沿边所包的木质套（或其他材料），压在墙上有几公分不等。哑口窗套单边哑口:只有一边有门套线的哑口为单边垭口，比如入户哑口。双边哑口：两边都有门套线的哑口为双边垭口，比如阳台哑口。 Window cover: refers to the window frame and the doorframe border side to wrap the wooden sleeve (or other material), presses on the wall to have several centimeters not to be unequal. Dumb dumb: unilateral window Mentao line only one side of the frame for single pass, such as home again. The bilateral frame on both sides of the line: dumb bilateral pass, such as the balcony door frame. 备注：如果测量未装修好的门洞的高度要注意房间地面铺设的复合地板、木地板、地砖、地暖气、或过门石的厚度要刨除。 Note: if the measurement is not good and the height of the decoration should pay attention to the room on the ground laying of composite flooring, wood flooring, floor tile, heating, or fill stone thickness should be excluded. 室内门标准门扇尺寸2000 x 800 x 40mm Indoor door standard door leaf size 2000 x 800 x 40mm |
| 上一页 实木门安装标准 |
| 下一页 烤漆门是越重越好吗？ |
Copyright © 技术支持：遨游网络