衡水电动伸缩门优质厂

实木门安装标准

Installation standard for solid wood doors

1、门套安装标准

, 1 door installation standards

在室内木门安装标准中，对门套做了这样的要求：它的装配连接处应该严密、平整、无黑缝;而固定配件应该紧密;在安装门套对角线时要注意对准，误差范围应该在1mm以内(2米以内)和1.5mm以内(2米以上)。安装好的门套应该横平竖直，垂直度方面允许有大2mm，水平平直度方面允许大1mm。

In interior doors installation standards, to do such a request to the door: it should be tight junction assembly, smooth, no black seam; and the fittings should be closely fixed; in the installation of door to the attention of the diagonal alignment error range should be within 1mm (2 meters) and 1.5mm (less than 2 meters). The door should be installed vertically, allowing the verticality of large 2mm, the level of flatness allows large 1mm.

2、套线安装标准

, 2 sets of lines installation standards

套线要和门套、墙体一起用胶水固定，接口处仍旧要平整、严密、无缝隙。在安装完成以后大家可以看看它有没有和侧套线在一个平面内。在误差方面，套线的弯度是允许有1mm的误差的。

Set line and door wall, together with glue fixed, the interface still need to be smooth, tight, seamless. After the installation is completed, you can see if it has a side sleeve in a plane. In the aspect of error set line camber is allowed to have the 1mm error.

3、门扇安装标准

3, standard for the installation of the door

门扇平整、垂直、开关灵活自如是是最基本的室内木门安装标准。除此之外，门扇与门套要露面相平，门套与门扇间的下缝隙应该为6至7mm，而门扇应该与密封条紧密结合，不能出现摆动的现象。

Leaf flat, vertical, flexible switch is the most basic standard for the installation of interior doors. In addition, the door and door to appearance is flat, the gap between the door and the door leaf under should be 6 to 7mm, and the door should be closely combined with the sealing strip, not swing phenomenon.

4、五金配件安装标准

4, standard for the installation of hardware accessories

五金配件中合页应该垂直、平整，槽口的大小要与合页一致;门锁开槽应准确、规范，大小与锁体、锁片一致;连接件、锁具灯都应该灵活自如，表面平整光滑。很多人在验收时会忘记五金配件，但这却是室内木门安装标准中很重要的一点。

Hinge hardware accessories should be vertical and smooth, consistent with the size of the notch hinges; lock slot should be accurate, standardized, and the size of the lock body, lock plate; connecting piece, lock lights should be flexible and comfortable, smooth surface. Many people forget hardware accessories when they are accepted, but this is a very important part of the indoor door installation standard.